Thursday, September 24, 2015

Get the Start and End Points of the BOTTOM of MEP Pipe System Families in Revit Using DynamoBIM

If you want to get the start and end points of the bottom of MEP Pipe system families in Revit simply add the nodes shown in the image below.



Why do you need this information you may ask? First of all, Revit does not easily display the start and end points at the bottom of a pipe families. So, use this information as you wish or tell a Revit Friend. I am sure someone you know will want to use it. Good Luck! 

3 comments:

JOSE LOZANO said...

Hi, how is step by step

Unknown said...

what version of revit and dynamo was this created in, attempted to recreate in revit 2016 and dynamo 1.0.0 and can not achieve the same results thanks

Unknown said...

what version of revit and dynamo was this created in, attempted to follow the steps in revit 2016 and dynamo 1.0.0 and could not get the same results. thanks