A blog dedicated to modeling and documenting complex geometry in the AEC industry using AUTODESK Products including DynamoBIM and DynamoBIM training.
Saturday, May 19, 2018
How to Place a Wall By Face Using Dynamo
Have you ever wanted to place a wall by face in Revit using Dynamo? Its easy. Simply follow the steps shown in the image below.
Note that only some surfaces in Revit allow walls to be hosted to them including Mass and Adaptive Component Surfaces . Try and experiment and good luck hosting those walls.
3 comments:
John Rogers
said...
Just found your site and wanted to say many thanks. I'm new to Dynamo and your basic examples, as opposed to your advanced examples, are a perfect blend of help yet effort on my part to progress me. Best regards, John
Howdy! This article could not be written much better! Going through this post reminds me of my previous roommate! He constantly kept talking about this. I most certainly will send this information to him. Fairly certain he'll have a very good read. Thanks for sharing!
I am trying to create a wall on the external facade of building. I want to lower most edge of wall and top most edge of wall to create a wall surface which is 15mm thk plaster. How do I do that?
3 comments:
Just found your site and wanted to say many thanks. I'm new to Dynamo and your basic examples, as opposed to your advanced examples, are a perfect blend of help yet effort on my part to progress me.
Best regards,
John
Howdy! This article could not be written much better!
Going through this post reminds me of my previous roommate!
He constantly kept talking about this. I most certainly will send
this information to him. Fairly certain he'll have a very good read.
Thanks for sharing!
Hey Hi,
I am trying to create a wall on the external facade of building. I want to lower most edge of wall and top most edge of wall to create a wall surface which is 15mm thk plaster. How do I do that?
Post a Comment